-
Jun 19, 2018, 02:53 AM
#21
-
Post Thanks / Like - 4 Likes
-
Jun 19, 2018, 06:38 AM
#22
-
Post Thanks / Like - 5 Likes
-
Jun 20, 2018, 07:11 PM
#23
So here's a rough sketch of what I will be trying to do.
Dimensions are very approximate, and will be refined once I upload the SW200/2824 manufacturing documents, and go over them like I did with the 7001.
So the plan is to show how to look at the manufacturing documents. Then some brief pics of my terrible 3d modelling based on the final specs from the manufacturing documents. Then 3d print on the low-res filament printer to check how it sits on the wrist (I tend to make them a bit to long and flat). Then update the model, and print it out on the high-res resin printer.
After that, repeat with a dial.
Might take a while to get through this though.
-
Post Thanks / Like - 3 Likes
-
Jun 24, 2018, 09:09 PM
#24
-
Post Thanks / Like - 1 Likes
-
Jun 25, 2018, 12:57 AM
#25
-
Post Thanks / Like - 3 Likes
-
Jun 25, 2018, 01:02 AM
#26
Originally Posted by
Dimman
And some pics from the earlier, not-so-successful case. Still close enough to try again. Was shooting for ~6mm, which meant cutting all the tolerances close, and maybe shouldn't have started with such an ambitious target. This 2824 build will be a little more conventional
Curious to see how things will turn out. Interesting thread, Dimman.
-
Post Thanks / Like - 2 Likes
-
Jul 1, 2018, 04:28 AM
#27
-
Post Thanks / Like - 3 Likes
-
Jul 2, 2018, 12:15 AM
#28
-
Post Thanks / Like - 2 Likes
-
Jul 2, 2018, 03:42 PM
#29
-
Post Thanks / Like - 5 Likes
-
Jul 2, 2018, 04:20 PM
#30
-
Post Thanks / Like - 1 Likes