Likes Likes:  0
Results 1 to 3 of 3

Thread: Regulation lever pusher tool

Threaded View

  1. Oct 11, 2020, 02:15 AM #1
    Mystic Nerd
    Mystic Nerd is offline
    Member
    Join Date
    Oct 2017
    Posts
    217

    Regulation lever pusher tool

    When working close up I don’t have good 3-D vision. I’ve had a difficult time getting an appropriate screwdriver blade positioned correctly against the regulator lever to push it. One time, I went down into the balance wheel and I will only say it did not turn out well.

    I ground a notch into the tip of this inexpensive 2 mm screwdriver blade. De-burred it afterwards, wiped and rinsed it and then wiped it again to hopefully eliminate all small bits of junk. It worked just as I hoped it would.

    Gently rest the short part of the blade tip on the top surface of regulator lever. The longer side of the tip is the pusher.

    Last edited by Mystic Nerd; Oct 11, 2020 at 02:19 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules and Guidelines

About Us
We are an independent and wide-ranging forum for watch enthusiasts. From mainspring to microchip, from Europe to Asia, from micro-brand to boutique - we cover it all. Novice or expert, we want you to feel at home. Whether it's asking a simple question or contributing to the fund of horological knowledge, it's all the same hobby. Or, if you like, you can just show us a picture of your new watch. We'll provide the welcoming and courteous environment, the rest is up to you!
Join us