Quote Originally Posted by tribe125 View Post
Let me check...

One minute later... no, this one doesn’t either. And actually, I wouldn’t expect it to. It’s only in fairly recent years that some high end quartz movements have had additional mechanisms to control backlash.

With a standard quartz movement (even a high accuracy one), it’s unlikely that the hand will hit all the markers. Paradoxically, some cheaper quartz movements hit the markers because they have tight movements - which shortens their life.

It wasn’t something I checked for with this watch. More important were a good bezel mechanism and a decent amount of thread on the screw-down crown.
Yeah, I think I let these things bother me more than I should sometimes.

After a service my Sub's bezel was a fraction of a mm from lining up with the minute markers. It drove me nuts and I made them change it, even though in reality it doesn't matter as it should be aligned to the hand's position (which is more than likely not going to be spot on a marker when you use it)